BTECH GMRS-50V2 - Read more about Remote Commands; DTMF Receive Settings, Transmit Setting (Call Key); 2 TONE Receive Settings, Transmit Setting (Call Key)

36
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
!
GMRS-50V2!
!
!
!
Read More About Remote Commands
An In-Depth explanation is available at: https://baofengtech.com/dtmf-remote-commands-on-the-uv-
5x3/ which details Remote Commands and how to use them. This web page explains, with examples, on
how DTMF remote commands are used
DTMF Receive Settings, Transmit Setting (Call Key)
1. Press the [MENU] Key select 18 OPTSIG, press the [MENU] Key, then select the DTMF function.
2. Press the [MENU] Key select 22 S-INFO, press the [MENU] Key, then select the pre-code signal
group (1-15). (The DTMF Signal must be saved first in the PC software setting under DTMF
settings.
3. If properly set up (on Menu 18), your radio will open the squelch when it receives the required
DTMF signal.
4. Press the [CALL] Key to send the same DTMF you have selected in Menu 22.
2TONE Receive Settings, Transmit Setting (Call Key)
1. Press the [MENU] Key select 18 OPTSIG, press the [MENU] Key, then select the 2TONE function.
2. Press the [MENU] Key select 22 S-INFO, press the [MENU] Key, then select the pre-code signal