VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
1. Press and hold for about 2 seconds
2. The Display will show: RANGE ---:---
3. Enter the Frequency Range (In MHz) Desired
4. Example: 144:146
5. The Radio will scan the frequency range from 144.000MHz-145.9975MHz According to Your
Frequency Step (See Menu 1 Description)
Tone!Scanning!
Scanning for CTCSS and DCS Tones/Codes!
Scanning for a CTCSS tone or DCS code can be done while Frequency Mode (VFO) or
Channel Mode (MR) is selected. Only when VFO mode is selected, can the detected
tone/code be saved to menu 11/10.
CTCSS tone and DCS code scanning mode can be accessed with or without a signal being present.
The scanning process itself only occurs while a signal is being received.
To Next Page
Loading...
