VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
&Scanning&for&a&DCS&tone&
(ACTIVE$SIGNAL$REQUIRED)$
1. Press the [MENU] key to enter the menu.!
2. Enter 10 on your numeric keypad to come to Menu 10: R-DCS
3. Press the [MENU] key to select. Insure you have a tone selected (and it is not off)
4. Press the to begin DCS scanning
A flashing "DCS" will be in the left status display to indicate the radio is in DCS scanning mode. In this
mode, whenever the radio is receiving an RF signal on the selected MR channel or VFO frequency, the
lower display will cycle through the DCS codes as they are being tested. Once the bits of the received
DCS code are determined, the "DCS" indicator will stop flashing and you will hear the signal.
Press the [MENU] key to save the scanned tone into memory (VFO Mode Only) then press the [MENU]
key to exit the menu.
Don't forget to set VFO menu 10 back to OFF when the DCS tone is no longer required.
To Next Page
Loading...
