ECM
®
830 Electroporation System
Page 6 www.btxonline.com
General Safety Summary
Review the following safety precautions to avoid injury and
prevent damage to this product or any products connected to it.
To avoid potential hazards, use this product only as specified.
Only qualified personnel should perform service procedures.
To Avoid Fire or Personal Injury
USE PROPER POWER CORD
Use only the power cord specified for this product and certified
for the country of use.
CONNECT AND DISCONNECT PROPERLY
Do not connect or disconnect probes or test leads while they are
connected to a power source.
GROUND THE PRODUCT
This product is grounded through the grounding conductor of the
power cord. To avoid electric shock, the grounding conductor
must be connected to earth ground. Before making connections
to the output terminals of the product, ensure that the product is
properly grounded.
OBSERVE ALL TERMINAL RATINGS
To avoid fire or shock hazard, observe all ratings and markings
on the product. Consult the product manual for further ratings
information before making connections to the product.
DO NOT OPERATE WITHOUT COVERS
Do not operate this product with covers or panels removed.
Use Proper Fuse. Use only the fuse type and rating specified for
this product.
AVOID EXPOSURE TO CIRCUITRY
Do not touch exposed connections and components when power
is present.
DO NOT OPERATE IN LOW IMPEDANCE
Sample: Load or Sample
If the electroporation samples have an impedance of less than
20 Ω in LV and 40 Ω in HV, the samples may arc and result in sam-
ple loss and potential damage to unit.
DO NOT OPERATE WITH SUSPECTED FAILURES
If you suspect there is damage to this product, have it inspected
by qualified BTX service personnel.
PROVIDE PROPER VENTILATION
Refer to installation instructions for details on installing the
product to ensure proper ventilation.
To Next Page
Loading...
