Buchi F-100 - Preparation for Use

6 Operation
20
F-100 / F-105 Operation Manual, Version C
Rear side
1
8
2
7
5
6
3
4
1 Cooling medium ow in
2 Cooling medium ow out
3 Power socket
4 Communication cable socket, RS485
(not available for F-100 models)
5 Fuse
6 Slots for air ow out
7 Antistatic wheels (not lockable)
8 Drainvalve, to empty the cooling medium tank
6.2 Preparing for use
Prerequisites
• All parts must be clean and free of damage.
• Close the drainvalve.
6.2.1 Installing the hoses
!
WARNING
Stumbling or falling due to improper installation of the cables and hoses.
• The length of the cables and hoses should be kept as short as possible
• If possible, avoid installing cables and hoses in aisle areas
• If installation of cables and hoses in aisle areas is unavoidable, use an adequate protective
pad in order to avoid the danger of stumbling and damage
• Connect out flow and return flow connections of the Recirculating Chiller with the condenser of the
rotary evaporator.
NOTE
Only use hoses which can withstand min. –10°C and 2bar pressure and secure them with the usual
hose clamps.
• Connect Chiller outlet (OUT) to the second condenser installed on the pump.
• Connect the outlet of the second condenser to the Rotavapor
®
Condenser.
• Connect the outlet of the Rotavapor
®
Condenser to the inlet (IN) of the Recirculating Chiller.