Installation manual
AM10 - We reserve the right to make any changes due to technical modifications!
6
1
1.4 Positioning outdoor
sensor
For best performance the outdoor sensor
is to be positioned where the sun can never
reach it. Mount only on a north facing wall
of the building, out of the sunlight, with at
least 1 foot (30 cm) above snow line. Keep
the sensor away from heat sources like
dryer, water heater, or boiler vents,
windows, etc.
Fig. 4 Sensor location
1.5 Single Boiler Control
To equip a single Buderus with outdoor
reset control, required items are:
• ON/OFF thermostat for every heating
zone with individual zone pump or zone
valve
•Pump relay
• Wiring
☺
☺
72186100-04N
To Next Page
Loading...
