Use of Detergent and Rinse Aid in the Dishwasher
Your Buffalo Dishwwasher has a detergent pump and a rinse-aid pump for use with containers of NON-
FOAMING liquid detergent.
1. Insert the hoses of the pumps in the correct chemical container (clear tube for detergent, blue tube
for rinse aid).
2. Ensure both of the hoses are at the bottom of the containers of the chemicals.
Note - The chemicals to be used should be suitable for Dishwashers. The detergent shall be the No Foam
type, suitable for Glass Washing machines.
Note - We recommend that you use detergent and rinse aid from the same manufacturer. Jantex Dishwash
detergent (CF976) & Jantex Dishwasher rinse aid (CF977) are recommended.
Note - When the machine is installed from new or when the containers are allowed to run dry, the full priming
takes place after 8-10 washing-rinsing cycles.
Detergent Pump
Detergent amount required is dependent on soil and water hardness. Dosage can be regulated via the control
panel. (See Changing Parameters section of this manual)
Rinse Aid Pump
Rinse Aid amount required is dependent on water hardness. Dosage can be regulated via the control panel.
(See Changing Parameters section of this manual)
Note – We recommend the use of a Water Softener to reduce limescale which can damage your machine
To Next Page
Loading...
