Priming Detergent and Rinse Aid
When using for the first time or if the detergent / rinse aid is allowed to run dry, detergent and rinse aid hoses will be
full with air. To prime detergent and rinse aid hoses use the following instructions -
Note:
Please use this option after the machine has reached the required temperature values
.
Press and hold the settings icon for 3 seconds
Enter the password “1” by using “up” and “down” buttons. Hold for 3 seconds to confirm
This will take you to the “Detergent filling screen”. To start priming detergent press start/pause button (Hold
3 sec). Detergent pump will start to run.
You can see the amount of detergent that you prime to the machine on the screen.
Press start/pause icon again when you want to stop priming the detergent
To prime the rinse aid press and hold the settings icon for 3 seconds
This will take you to the “Rinse Aid filling screen”. To start priming Rinse Aid press start/pause button (Hold 3
sec). Rinse Aid pump will start to run.
You can see the amount of Rinse Aid that you prime to the machine on the screen.
Press start/pause icon again when you want to stop priming the Rinse Aid
To Next Page
Loading...
