6
Fault Probable Cause Solution
Sealing Bar requires replacement Call BUFFALO agent or qualified technician
Sealing bar/lid seal is dirty Clean sealing bar/lid seal
Error message E
in Digital Display
Machine has overheated Switch off Power and leave for 20 minutes
Error message
E01 in Digital
Display
The lid is open while the machine is
in heating mode
Close the lid. If the error code persists, there
may be something wrong with the micro
switch, thus Call BUFFALO agent or qualified
technician
NOTE: Sealing bar replacement is not covered under warranty
Technical Specifications
Model Voltage Power Current
Vacuum Pressure
(approx.)
Dimensions
h x w x d mm
Weight
(kg)
GF439 230V 50Hz 630W 3A -992mbar 429 x 359 x 378 24.4
Electrical Wiring
This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible for
waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal authorities.
BUFFALO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to
change specifications without notice.
GF439_ML_A5_v6_20190829.indb 6 2019/8/29 14:22
To Next Page
Loading...
