The seatback will lock into place when you push it
back to the upright position. After raising a
seatback to an upright position, push and pull on
the seatback to make sure that it is locked in
place.
Removing the Split Bench Seat
Each section of the split bench seat can be flipped
forward or removed individually.
1. Unlatch the shoulder belt from the lap-belt.
2. Make sure that the seatback is in the upright
position.
Notice: Folding a rear seat with the safety
belts still fastened may cause damage to the
seat or the safety belts. Always unbuckle
the safety belts and return them to their normal
stowed position before folding a rear seat.
3. Lift up or push forward on the seatback
recliner lever to fold the seatback forward.
4. For base-level split bench seats, pull the lever
at the base of the seat on the outboard side
to release the rear latches from the floor
pins and flip the seat forward.
Base-Level
17
To Next Page
Loading...
Need help?
General
