The split bench seat sections have seat position
labels, located on the back of each section,
showing where the section must go.
The seat must be placed in the proper location for
the legs to attach correctly.
1. Squeeze the angled latch release bar toward
the straight crossbar while placing the front
hooks of the bench seat onto the front
two floor pins.
2. Make sure that the
bench seat is angled
so that the front
hooks clear the floor
pins. If the front
legs are not
attached correctly,
the rear legs will not
attach to the rear
set of floor pins.
20
To Next Page
Loading...
Need help?
General
