Interior Lighting Delay
The interior lighting delay feature can be
programmed to one of the following modes:
OFF: This feature will not illuminate the interior of
your vehicle when all of the doors are closed.
ON: This feature will continue to illuminate
the interior lamps for 25 seconds after all doors
have been closed so that you can find the ignition
and buckle your safety belt at night.
Interior lighting delay will not occur while the
ignition is in ON. After 25 seconds, the interior
lamps will fade out. The lamps will fade out before
the 25 seconds if one of the following occurs:
• The ignition is turned to ON
• All doors are locked using the Remote
Keyless Entry (RKE) transmitter
• There is no occupant activity detected for an
illumination period of 25 seconds
Your vehicle was originally programmed to ON.
The mode may have been changed since then.
To determine the current mode, or to change
the mode, do the following:
1. Follow the instructions for “Entering
Programming Mode” listed previously.
2. Press the MODE button until INTERIOR
LIGHTING DELAY appears on the DIC.
3. Press the SET button until the arrow is before
ON or OFF.
The mode you selected is now set. You can either
exit programming mode by following the
instructions later in this section or program the
next feature available on your vehicle.
242
To Next Page
Loading...
Need help?
General
