Delayed Locking
The delayed locking feature can be programmed
to one of the following modes:
ON: Lock your vehicle using the power door
lock switch or the Remote Keyless Entry (RKE)
transmitter while any door is opened, you will
hear three chimes and the doors will not lock.
Five seconds after the last door is closed, all doors
will lock.
Once delayed locking is programmed to ON, you
can do the following:
• Cancel the delayed locking by pressing unlock
using the power door lock switch or by fully
inserting the key in the ignition
• Override the delayed locking feature by
pressing lock immediately using the power
door lock switch
• Let the delayed locking feature complete the
locking of the vehicle
OFF: The doors will always lock immediately
when you lock the doors using the power door lock
switch or press LOCK on the RKE transmitter.
Your vehicle was originally programmed to
ON. The mode may have been changed since
then. To determine the current mode, or to change
the mode, do the following:
1. Follow the instructions for “Entering
Programming Mode” listed previously.
2. Press the MODE button until DELAYED
LOCKING appears on the DIC.
3. Press the SET button until the arrow is before
ON or OFF.
The mode you selected is now set. You can either
exit programming mode by following the
instructions later in this section or program the
next feature available on your vehicle.
245
To Next Page
Loading...
Need help?
General
