A. Outboard Taillamp
B. Center Taillamp
C. Inboard Back-Up Lamp
6. Turn the bulb socket counterclockwise
one-quarter of a turn.
7. Pull the bulb assembly out from the lamp
housing.
8. Pull the bulb out of the base.
9. Install the new bulb into the electrical
connector. Push the bulb firmly enough so
that the tabs hook over the tab on the bulb.
10. Put the bulb assembly back into the lamp
housing and turn the bulb socket clockwise
one-quarter of a turn.
11. Reinstall the lamp assembly on the liftgate.
12. Gently lift the liftgate.
13. Reinstall the seven wing nuts and the four
outboard nuts.
14. Reinstall the panel inside the liftgate by
connecting the tabs.
15. Close the liftgate.
403
To Next Page
Loading...
Need help?
General
