Bulldog Security RS1100

To Next Page

CONTENTS

REMOTE STARTER

MODELS RS1100/RS1100E, RS114

INSTALLATION GUIDE

•

OWNER’S GUIDE

Technical Assistance

All tech personnel are expertly qualified to answer any technical questions.

Technicians are available Monday through Friday from 9:00 a.m. until 8:00 p.m. and Saturday 10:00 a.m. until 4:00 p.m.

Address

288 Canton Avenue • Wintersville, Ohio 43953

Telephone

Phone: 740-264-4710 • 800-878-8007 • Fax: 740-264-7306

System Features....................................... 1

System Components..................................... 1

Required Tools........................................ 1

Technical Assistance .................................. 1

Before You Begin ...................................... 2

Precautions........................................... 2

Using your Test Probe ................................. 2

Making Connections .................................... 3

Locating & Making Connections........................ 4-6

Neutral Safety Switch ................................. 6

Connecting Wiring Harness ............................. 6

Antenna Placement ..................................... 7

Anti-Theft System ..................................... 7

Optional Features ................................... 7-9

Operator Programming Instructions ................... 9-10

How to use Your Remote Transmitter.................. 10-11

Main Page

Other manuals for Bulldog Security RS1100

Manual12 pages

Need help?

Do you have a question about the Bulldog Security RS1100 and is the answer not in the manual?

Summary

System Features

Four-Button Extended Range Remote Control

Remotely start your car to run the heater, air conditioning or defroster from an extended distance.

Keyless Entry

Remotely locks and unlocks your power door locks.

Precautions

Safety First

Never remotely start your vehicle indoors, with the keys in the ignition or unless the transmission is in park.

Warning

General Motors Rear Wheel Drive Vehicles and Dodge Dakotas built prior to 1996 do not have an electrical neutral safety switch.

Making Wiring Connections

Making End to End Connections

Use this method ONLY when connecting two separate wires end to end.

Locating and Making Connections

Constant Power (+12 V)

Locate constant power wire in the vehicle's main ignition harness, usually in the steering column.

Ignition Wire(s) (+12 V)

Locate ignition wire(s) in the main harness, showing +12V in run and crank positions.

Accessory Wire(s) for Heater;Blower

Locate accessory wire(s) in the main ignition switch harness showing +12V in run or on positions.

Starter;Crank Wire (+12 V)

Locate the starter/crank wire showing +12V only in the crank position.

Chassis Ground

Locate an easy-to-get-to bolt or screw under the driver's side dash for the black ground wire.

Hood Pin Switch (-)

Brake Input (+)

Neutral Safety Switch

Connecting the Wiring Harness

Factory Anti-Theft Systems

Optional Connections

Testing Door Locks

Tests vehicle door lock systems to determine Type A, B, or C for proper connection.

Operator Programming Instructions

Adding Additional Remotes

Tach Learn

How to Use Your Remote Transmitter

Starting the Vehicle

Procedure to start the vehicle using button #1 on the remote transmitter.

Pit Stop: Exiting the Car