Bully Dog ECM Tuner - Page 36

35
ECM TUNER
Introduction
Updating
Physical
Installation
Installing the
Tune
Uninstalling
the Tune
Operating the
HDGT
More
Information
6. Double-check and conrm that you have selected the
correct vehicle type.
‣ If the vehicle is not correct,
you can choose NO (bottom
right button) or Go Back (top
left button) to change to the
correct vehicle type.
a. Press YES (top right button) to
continue.
7. The ECM Tuner will then load and boot the image (the
vehicle les).
‣ This process is fast, it should not take longer than
three minutes.
‣ The ECM Tuner will show a percentage counter
while it is loading; then the screen will darken and
the device will chirp for approximately ve seconds
while it reboots.
8. The ECM Tuner will update les (load the graphics le
from the memory card to the device).
‣ This process is fast and may
take one minute or less.
‣ The ECM Tuner will show a
percentage counter to track
its progress.
Go Back
NO
YES
Are you sure your vehicle is
CAT
Press YES to continue.
VEHICLES
LOADING IMAGE
58%
Selected:
XXXXXXXXXXXXXX
Loading le from SD card.
BOOTING IMAGE
Screen will darken and Device
will chirp for 5 seconds.
Do not unplug or cycle key.
UPDATING FILES
47%
Loading graphics le from SD card.