Bunn Crescendo Series User Manual

12
MODIFYING THE TOUCH SWITCH FUNCTIONS
The function of the touch switch can be modified in four different ways:
1. Set for single cup size dispensing.
2. Move any default beverage from one switch location to another.
3. Disable a dispense switch.
4. Create a “custom” beverage.
Single Cup Mode
When the SINGLE cup size beverage mode is selected, the large and small cup size buttons are disabled.
To dispense a beverage, press only the dispense button of the beverage desired. The option to select which
beverage size is used can be done when creating a custom recipe or espresso dispense.
Tip: A display graphic for single cup dispensing is availble for purchase from BUNN.
CREATING A “CUSTOM” BEVERAGE
A “CUSTOM” beverage may be edited/created for any dispense switch location. It is recommended that the touch switch
graphic insert be replaced with one which matches the beverage reassignments made in this mode. All settings can be
adjusted to preference.
Set Espresso Shots
The sub-menus for adjusting an espresso shot are located under this option.
• Set the toggle switch to
Program mode.
STEP 1
• Advance to the Set Espresso
Shots screen.
STEP 2
PROGRAM MODE
PRESS TO ENTER
• Press SELECT.
STEP 3
1. SELECT SIZE
Use to Navigate
SET ESPRSO SHOTS
EXIT YES
1. SELECT SIZE
Use to Select
• Sets the grinder run time for a
small espresso shot.
• Navigate to the next setting.
STEP 4
SM ESP GRIND TIME
(-) #.# sec (+)
1. SELECT SIZE
Use to
Navigate
Use to
decrease
Use to
increase
• Sets the percentage of full
voltage to piston motor for
tamping the dry puck.
• Navigate to the next setting.
STEP 5
1. SELECT SIZE
Use to
Navigate
Use to
decrease
Use to
increase
• Sets the espresso pump
run time for pre-infusion of
tamped coffee. Zero seconds
for no pre-infusion.
• Navigate to the next setting.
STEP 6
SM PREINFUSION
(-) #.# sec (+)
1. SELECT SIZE
Use to
Navigate
Use to
decrease
Use to
increase
SM DRY TAMP%
(-) ### (+)
042319

Bunn Crescendo Series Specifications

General

Beverage Options	Coffee
Grinder	No
Voltage	120 V
NSF Listed	Yes
Material	Stainless Steel
Phase	1