How to switch Burkert 3360 from MANUAL operating state?
If the Control Unit by Burkert is in MANUAL operating state, it means the device is in the MANUAL operating state. Switch to AUTOMATIC operating state.
What to do if the Control Unit by Burkert detects undervoltage?
If the Control Unit by Burkert detects undervoltage, it indicates a supply voltage failure or that the supply voltage is too low for the device to operate. You should check the supply voltage, and if the problem persists, contact Bürkert Service.
How to fix 'Energy storage must be replaced' error on Burkert 3360?
If the Control Unit by Burkert displays 'Energy storage must be replaced,' it means the storage capacity of the energy storage is too low, and the safety position cannot be guaranteed. Replace the energy storage SAFEPOS energy-pack.
What to do if Burkert 3360 Control Unit says 'No energy storage available'?
If the Control Unit by Burkert displays 'No energy storage available,' it means the SAFEPOS energy-pack is not detected. Check whether the SAFEPOS energy-pack is correctly installed.
What to do if the Control Unit by Burkert detects excess temperature?
If the Control Unit by Burkert detects excess temperature, it signifies that the device temperature is too high for operation. Reduce the ambient temperature. If the problem persists, contact Bürkert Service.
What does 'BueS event: producer is not operational' mean on my Burkert Control Unit?
If the Control Unit by Burkert displays 'BueS event: producer is not operational,' it means the producer is not operational in this state. Check the büS/CANopen producer.
What does 'BueS event: bus connection lost/not available' mean on my Burkert 3360?
If the Control Unit by Burkert displays 'BueS event: bus connection lost/not available,' it means the büS/CANopen network cannot be found. Check the büS/CANopen network.
What does 'BueS event: a device is using the same address' mean on my Burkert 3360 Control Unit?
If the Control Unit by Burkert displays 'BueS event: a device is using the same address,' it means another büS/CANopen participant is using the same address. Assign a unique address to the device and büS/ CANopen participant.
What to do if the Control Unit by Burkert shows 'Voltage warning limit exceeded'?
If the Control Unit by Burkert displays a voltage warning limit exceeded, it indicates that the supply voltage is too high. Check the supply voltage.
What to do if the Control Unit by Burkert shows 'Temperature warning limit exceeded'?
If the Control Unit by Burkert displays a temperature warning limit exceeded, it indicates that the ambient temperature is too high or there is increased friction in the actuator train. Reduce the ambient temperature. Contact Bürkert Service if the problem persists.
General| Brand | Burkert |
|---|---|
| Model | 3360 Series |
| Category | Control Unit |
| Language | English |
To Next Page
