Burkert 5282 - Malfunctions; SPARE PARTS; Ordering spare parts

12
6.2 Malfunctions
If malfunctions occur, check whether:
→ the device has been installed according to the instructions,
→ the electrical and uid connections are correct,
→ the device is not damaged,
→ all screws have been tightened,
→ the voltage and pressure have been switched on,
→ the pipelines are clean.
Malfunction Possible cause
Valve does
not switch
Short-circuit or coil interrupted
Medium pressure outside the permitted pressure range
Manual emergency actuation locked
Valve does
not close
Internal space of the valve is dirty
Manual emergency actuation locked
NOTE!
Explosion protection versions may only be repaired by the
manufacturer.
7 SPARE PARTS
CAUTION!
Risk of injury and/or damage by the use of incorrect parts!
Incorrect accessories and unsuitable spare parts may cause injuries
and damage the device and the surrounding area.
▶ Use original accessories and original spare parts from Bürkert only.
7.1 Ordering spare parts
Replacement part sets
Order the spare-part set SET 3 or the pilot control with solenoid coil (com-
plete) by quoting the identication number of the device.
• See replacement part sets “7.2 Exploded drawing”.
• The identication number of the device can be found on the type label.
See also chapter “4.5 Type label”.
english