Burley LADY BUG - Interior Features and Child Restraints; Seat, Harness, and Helmet Pocket Setup

16 BURLEY TRAILER OWNER’S INSTRUCTION AND SAFETY MANUAL
Padded Seat & Shoulder Harness, Child Seat
Recliner, and Recessed Helmet Pocket
(d’Lite
™
, Solo
™
, Lady Bug
™
, Cub
™
)
To Install Seat Pad:
Attach the seat pad Velcro hook strips to the loop Velcro strips on the seat.
To Install Shoulder Harness Pad:
Insert the shoulder straps into the shoulder harness pad as shown in the
drawing at the right. The shoulder straps should
be oriented so that the FLAT parts of the male
buckles are facing toward each other.
Using the Child Seat Recliner
The child seat can be reclined for
added comfort by making the following
adjustments:
1. Loosen the tension on the straps (A)
attached to the top of the frame.
2. Loosen the tension in the helmet
pocket straps (B).
Using the Recessed
Helmet Pocket
(d’Lite
™
, Solo
™
, Lady Bug
™
, Cub
™
)
The helmet pocket, which is designed
to provide added room for the back
side of a child’s helmet, can be
modifi ed by loosening/tightening the
helmet pocket straps (B)
as required.
Using the Child Seat Divider
(d’Lite
™
, Lady Bug
™
only)
This feature keeps two passengers from sliding to the center of the seat.
Connect center crotch strap O-ring to snap hook located on the front splash
guard. Adjust strap tension with the plastic slider on the crotch strap.
NOTE: Use the Seat Divider feature only when transporting two passengers.
B
A