BURLEY TRAILER OWNER’S INSTRUCTION AND SAFETY MANUAL 7
Unfolding Your Burley Trailer
To unfold your trailer, rotate the front tube upward and the rear tube back
until they meet on the two plastic saddles. Then rotate the two frame locks
to snap onto the rear tube. The frame locks should connect adjacent to, and
to the outside of, the two plastic saddles.
d’Lite
™
, Encore
™
, Lady Bug
™
, Cub
™
– After the frame locks are locked in place,
attach the hooks on the seat sides to the D-rings by the windows inside the
trailer.
Solo
™
only – After the frame locks are locked in place, clip the female buckle
ends on the two seat side straps into the male buckle ends on the inside of
the frame.
Check that the frame locks are properly engaged before using the
trailer. Failure to do so can result in serious injury.
WARNING
Frame locks snapped
into closed position
onto rear tube.
Rear
Front
Seat clips attach
to the top of the
frame.
Seat clips
To Next Page
Loading...
