Burmester 077 - Amplification and Input 6 Configuration; Setting Amplification and Input 6 Mode

24
Amplification It is possible to adjust the total amplification of the MAIN level of your preamp for an
improved level adjustment to the connected power amps or active speakers.
Select menu item M-OUT with the left rotary switch or the navigation buttons
 
on your
remote control.
With the right rotary switch or the navigation buttons
 
on your remote control you may
select one of the following:
HIGH high amplification, max. +21dB (factor 11.2)
LOW low amplification, max. +5dB (factor 1.8)
To operate BURMESTER power amps we recommend the setting LOW.
Configuration of Through factory settings the INPUT 6/SURR (23) of the preamp 077 is preset as a surround
INPUT 6 input for the MAIN level, i.e. the signal is transported directly to the MAIN output, avoiding
volume control and all amps.
Instead, if you prefer not to connect a surround decoder, you may use the input as a regular
high-level input with volume control (like INPUT 1 to 5) by changing the presetting.
Select menu item M-IN6 with the left rotary switch or the navigation buttons
 
on your
remote control.
With the right rotary switch or the navigation buttons
 
on your remote control you may
select one of the following:
SURR Input 6 is set as a SURROUND input
INP Input 6 is set as a regular high-level input
PLEASE NOTE: If the setting SURR is selected, a security check via display will follow M-
IN6:SU OK?. Now confirm by pushing the OK button on your remote control.