EasyManuals Logo

Burmester Classic Series User Manual

Burmester Classic Series
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
10
GENERAL INSTRUCTIONS
Operating temperature An operating temperature that is too high or too low may cause malfunctioning. We
therefore recommend letting the 032 sit for a while after unpacking and before connecting
and operating it.
Terminals The pins of the connecting terminals on the back panel should not be touched by fingers
under any circumstances. Static discharges may damage the electronic circuitry inside the
unit.
IR receiver The IR receiver (1) receives signals from the BURMESTER remote control and must not be
covered up by objects.
Heat development Be careful when touching the housing – it may get quite warm during operation.
Reset If the unit does not react when pressing the control keys on the front it may be reset to
normal operation by switching it off and back on using the AC mains switch in the back.
Lightening strikes During the summer months, malfunctions often occur due to voltage spikes in the power
lines after lightning strikes. Completely unplugging the power cord offers the only effective
protection. Merely switching the 032 off does not suffice since voltage spikes are able to arc
over separated contacts.
Interconnects We supply custom-made balanced as well as unbalanced interconnect cables and speaker
cables of any length to ensure highest-quality signal paths for our components. The
impedance of our cables is ideally matched to all BURMESTER components.
For the cleanest power supply we recommend our triple-shielded power cord BURMESTER-
POWER.
Fuses The fuses are located inside the unit and should be changed only by a qualified technician.
Voltage Check before operating the 032 to see if the voltage setting shown on the back panel below
the AC mains input conforms to voltage of your household power supply. Any change
should only be done by an expert.
Warranty We offer warranty for this unit provided the 032 has been hooked-up and operated
correctly, is mechanically undamaged.
Opening the unit, modifying it or dismantling outlets will void the warranty.
Care Never clean the housing with a wet cloth or chemical cleaning agent. Always make sure that
no liquid gets into the housing.
CAUTION Before opening the housing or changing the fuses always unplug the unit from the
wall outlet. DANGER OF ELECTRIC SHOCK!

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Burmester Classic Series and is the answer not in the manual?

Burmester Classic Series Specifications

General IconGeneral
BrandBurmester
ModelClassic Series
CategoryAmplifier
LanguageEnglish

Related product manuals