Burson Conductor 3X - Menu Items

USB interface software setup guide.
When connecting the Conductor 3XR to OSX, iOS or Android systems, no driver is needed.
For use with Windows OS, a driver is required. You can download a driver from our website:
https://www.bursonaudio.com/downloads/
Please download the latest Windows driver: Burson_UsbAudio_v4.59.0_2019-04-02_setup.exe
Break-in, Warm-up and Caring.
The sound of the Burson Conductor 3XR improves steadily within minutes after powered-up. Depending on the
resolution of the system and the attentiveness of the listener, you may find that the sound continues to improve
over the first weeks of operation.
Never connect or disconnect the RCA or XLR output cables from the Conductor 3XR while music is playing. This
could damage the Conductor 3XR. Please stop the music source before disconnecting.
Menu Items
Input
USB
PCM 32bit 786K / DSD512
Toslink
PCM 24bit 192K
Coaxial
PCM 24bit 192K
Bluetooth
PCM 24bit 96K
XLR 1 & 2
XLR line-level input
Output
Pre Out
Pre Amp output with
volume control
DAC Out
2V RMS line-level No
volume control
HP Out
Headphone Out
Gain Level
High* / Med /Low
High / Med /Low
FIR Filter
Brickwall, CMFR, Reserved, AP Fast*, MP
Slow, MP Fast, LP Slow, LP Fast
See FIR Filter section
below
DPLL (DSD)
DPLL Off / Low / Mid / High*
DSD file playback setting
DPLL (PCM)
DPLL Off / Low / Mid / High*
PCM file playback setting
DE-EMPHASIS
On / Off*
Only turn on if your source
is a cassette tape
player
RESTORE SETTINGS
YES / NO
This resets the unit back
to default factory
settings
Default selection marked with*
5