BUSCH Panda WV 2000 C - Page 21

Troubleshooting | 11
Instruction Manual PANDA WV 0250-2000 C_EN_en 21 / 24
The machine runs too hot. Ambient temperature too
high.
• Observe the permitted
ambient temperature, see
Technical Data [►22].
Temperature of the process
gases at the inlet too high.
• Observe the permitted
gas inlet temperature, see
Technical Data [►22].
Oil level too low. • Top up oil.
The backing pump is not
correctly defined.
• Contact Busch.
The oil is black. Oil change intervals are too
long.
• Drain the oil and fill in
new oil, see Oil Change
[►16].
The machine runs too hot. • See problem "The ma-
chine runs too hot".
For the solution of problems not mentioned in the troubleshooting chart contact your
Busch representative.