What to do if my BUSCH Water Pump fumes or expels oil?
If your BUSCH Water Pump is fuming or expelling oil droplets through the gas discharge, check these: * The exhaust filters are partially clogged: Replace the exhaust filters. * An exhaust filter with o-ring is not fitted properly: Ensure the correct position of the exhaust filters and the o-rings.
Why is the oil in my BUSCH Water Pump black?
The oil in your BUSCH Water Pump might be black due to: * Oil change intervals are too long: Flush the machine (contact Busch). * The inlet filter is defective: Replace the inlet filter. * The machine runs too hot: See problem "The machine runs too hot".
What causes emulsified oil in a BUSCH Water Pump?
If the oil in your BUSCH Water Pump is emulsified, it suggests: * The machine sucked in liquids or significant amounts of vapour: Flush the machine (contact Busch). * The machine sucked in liquids or significant amounts of vapour: Clean the filter of the gas ballast valve. * The machine sucked in liquids or significant amounts of vapour: Modify the operational mode (see Conveying Condensable Vapours).
What to do if my BUSCH Water Pump runs too hot?
If your BUSCH Water Pump is running too hot, there are several potential causes and solutions: * Insufficient cooling: Remove dust and dirt from the machine or check the cooling fan. * Ambient temperature too high: Ensure that you observe the permitted ambient temperature. * Oil level too low: Top up the oil. * The exhaust filters are partially clogged: Replace the exhaust filters.
What to do if my BUSCH Water Pump does not reach the usual pressure?
If your BUSCH Water Pump does not reach the usual pressure on the suction connection, consider the following: * Oil level too low: Top up the oil to the correct level. * The inlet screen is partially clogged: Clean the inlet screen to ensure proper flow. * The inlet filter cartridge is partially clogged: Replace the inlet filter cartridge. * Internal parts are damaged: Repair the machine (contact Busch).
Why won't my BUSCH Water Pump start?
If your BUSCH Water Pump doesn't start, it could be due to these reasons: * The motor is not supplied with the correct voltage: Check the power supply to ensure it is providing the correct voltage. * The motor is defective: Repair the machine (contact Busch).
Why is my BUSCH Water Pump running very noisily?
If your BUSCH Water Pump is running very noisily, it could be due to: * Stuck vanes: Repair the machine (contact Busch). * Defective bearings: Repair the machine (contact Busch).
Specifies essential environmental and placement requirements for optimal machine performance and safety.
Details safe electrical connection procedures, compatibility checks, and protection measures for the motor.
Outlines recommended maintenance intervals and corresponding tasks for weekly, monthly, and periodic checks.
Procedure for checking the oil level, including machine shutdown and waiting time before inspection.
Details the process for changing the machine's oil, referring to drain pan and oil fill plug locations.
Addresses issues like machine not starting, pressure loss, and noise, with possible causes and solutions.
Covers problems like overheating, oil fumes, black oil, and emulsified oil with corrective actions.
General| Brand | BUSCH |
|---|---|
| Model | R 5 KC 0016 E |
| Category | Water Pump |
| Language | English |
To Next Page