EasyManua.ls Logo

BUSCH R 5 RA 0302 D - User Manual

BUSCH R 5 RA 0302 D
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
O
2
Instruction Manual
R 5 Oxygen
Oil-Lubricated Rotary Vane Vacuum Pumps
RA 0160 D, RA 0202 D, RA 0250 D, RA 0302 D
(Version intended for OEM only)
0870573103/-0001_en / Original instructions / Modifications reserved 30/05/2017
Ateliers Busch S.A.
Zone industrielle, 2906 Chevenez
Switzerland

Questions and Answers

  • J
    Jason LopezAug 9, 2025
    Why does my BUSCH R 5 RA 0302 D Water Pump run too hot?
    • G
      Gerald TapiaAug 9, 2025
      If your BUSCH Water Pump runs too hot, it could be due to several reasons. First, remove any dust and dirt from the machine to ensure sufficient cooling. Also, make sure that the ambient temperature is within the permitted range. Check the oil level and top up if it's too low. Finally, if the exhaust filters are partially clogged, replace them.
  • Y
    Yolanda DavisAug 14, 2025
    What to do if my BUSCH Water Pump does not reach the usual pressure?
    • J
      Jennifer ParksAug 14, 2025
      If your BUSCH Water Pump is not reaching its usual pressure, the oil level might be too low, so top it up. Also, the inlet screen could be partially clogged; clean it. If you have an optional inlet filter cartridge, it might be clogged and needs replacement. If none of these resolve the issue, the internal parts may be worn or aged, and you should contact Busch for repair.
  • K
    Kristy CoxAug 21, 2025
    Why is my BUSCH R 5 RA 0302 D Water Pump fuming or expelling oil?
    • M
      Mr. Gabriel SmithAug 21, 2025
      If your BUSCH Water Pump is fuming or expelling oil droplets through the gas discharge, the exhaust filters may be partially clogged, so replace them. Also, ensure the correct position of the exhaust filters and the O-rings. Check the float valve and the oil pipe for any clogging, and remove any blockages found.
  • O
    ofrazierAug 27, 2025
    How to fix a BUSCH Water Pump that does not start?
    • L
      Lisa DunlapAug 27, 2025
      If your BUSCH Water Pump does not start, check the power supply to ensure the motor is getting power. If the motor is defective, replace it. Also, inspect the coupling; if it's defective, replace it as well.
  • D
    Dustin FloresSep 1, 2025
    Why is my BUSCH Water Pump running very noisily?
    • K
      Kerri HillSep 1, 2025
      If your BUSCH Water Pump runs very noisily, the coupling might be defective and needs replacement. Alternatively, the vanes could be stuck, or the bearings might be defective. In the latter two cases, contact Busch for repair.

Summary

1 Safety

5 Installation

5.1 Installation Conditions

Specifies the environmental and physical requirements for installing the machine.

5.2 Connecting Lines and Pipes

Details the connection of suction and discharge lines.

5.3 Filling Oil

Instructions on how to fill the machine with the correct type of oil.

5.4 Electrical Connection

Guidelines for making the electrical connections to the machine.

6 Commissioning

7 Maintenance

7.1 Maintenance Schedule

Outlines recommended intervals and tasks for routine maintenance.

11 Troubleshooting

12 Technical Data

BUSCH R 5 RA 0302 D Specifications

General IconGeneral
BrandBUSCH
ModelR 5 RA 0302 D
CategoryWater Pump
LanguageEnglish

Related product manuals