Why is the oil in my BUSCH R 5 RA 1600 B black?
If the oil in your BUSCH Water Pump is black, it could be due to several reasons. The oil change intervals might be too long, in that case you should contact Busch to flush the machine. The inlet filter might be defective and need replacement. Also, the machine might be running too hot; refer to the troubleshooting steps for that specific problem.
Why is my BUSCH R 5 RA 1600 B running too hot?
If your BUSCH Water Pump is running too hot, it could be due to several reasons. First, check for insufficient cooling and remove any dust or dirt from the machine. Second, ensure that the ambient temperature is within the permitted range. Also, check the oil level and top up if it's low. Finally, the exhaust filters might be partially clogged, so replace them if necessary.
What to do if my BUSCH R 5 RA 1600 B does not reach the usual pressure?
If your BUSCH Water Pump isn't reaching the usual pressure on the suction connection, there are several potential causes. First, check the oil level and top it up if it's low. Second, the inlet screen might be partially clogged, so clean it. Third, if your model has an inlet filter cartridge, it might be clogged and need replacement. Finally, internal parts may be worn or damaged, requiring you to contact Busch for repair.
Why is my BUSCH R 5 RA 1600 B fuming or expelling oil?
If your BUSCH Water Pump is fuming or expelling oil droplets through the gas discharge, the exhaust filters might be partially clogged, so replace them. Also, ensure that the exhaust filter with o-ring is fitted correctly. Finally, check the float valve and oil pipe for any clogging and remove it.
How to fix a BUSCH Water Pump that does not start?
If your BUSCH Water Pump does not start, it could be due to a few reasons. First, the motor might not be supplied with the correct voltage, so check the power supply. Second, the motor itself could be defective and need replacement. Finally, the coupling might be defective and also need replacement.
What causes a BUSCH R 5 RA 1600 B Water Pump to run very noisily?
If your BUSCH Water Pump is running very noisily, it could be due to several reasons. The coupling might be worn and need replacement. Alternatively, the vanes could be stuck, or the bearings could be defective. For the last two issues, contact Busch for repair.
General| Weight | 1150 kg / 2535 lbs |
|---|---|
| Type | Rotary Vane Pump |
| Max Flow Rate | 1600 m³/h |
| Frequency | 50 Hz |
| Hose Connection | DN 100 |
To Next Page