To Next PageTo Next PageWhy does my BUSCH R 5 RA 0202 D Water Pump run too hot?
If your BUSCH Water Pump runs too hot, it could be due to several reasons. First, remove any dust and dirt from the machine to ensure sufficient cooling. Also, make sure that the ambient temperature is within the permitted range. Check the oil level and top up if it's too low. Finally, if the exhaust filters are partially clogged, replace them.
What to do if my BUSCH R 5 RA 0202 D Water Pump does not reach the usual pressure?
If your BUSCH Water Pump is not reaching its usual pressure, the oil level might be too low, so top it up. Also, the inlet screen could be partially clogged; clean it. If you have an optional inlet filter cartridge, it might be clogged and needs replacement. If none of these resolve the issue, the internal parts may be worn or aged, and you should contact Busch for repair.
Why is my BUSCH R 5 RA 0202 D Water Pump fuming or expelling oil?
If your BUSCH Water Pump is fuming or expelling oil droplets through the gas discharge, the exhaust filters may be partially clogged, so replace them. Also, ensure the correct position of the exhaust filters and the O-rings. Check the float valve and the oil pipe for any clogging, and remove any blockages found.
How to fix a BUSCH R 5 RA 0202 D Water Pump that does not start?
If your BUSCH Water Pump does not start, check the power supply to ensure the motor is getting power. If the motor is defective, replace it. Also, inspect the coupling; if it's defective, replace it as well.
Why is my BUSCH R 5 RA 0202 D Water Pump running very noisily?
If your BUSCH Water Pump runs very noisily, the coupling might be defective and needs replacement. Alternatively, the vanes could be stuck, or the bearings might be defective. In the latter two cases, contact Busch for repair.
General| Brand | BUSCH |
|---|---|
| Model | R 5 RA 0202 D |
| Category | Water Pump |
| Language | English |
Specifies environmental and siting requirements for safe machine installation.
Instructions for connecting suction and discharge lines to the machine.
Instructions and warnings for filling the machine with the correct type of oil.
Critical safety information and procedures for making electrical connections.
Provides various wiring diagrams for three-phase motor configurations.
Outlines recommended maintenance tasks and intervals for the machine.
Details the procedure for checking the machine's oil level.
Instructions for changing the machine's oil and oil filter.
Step-by-step guide for replacing the exhaust filters.
