How to troubleshoot a BUSCH R 5 RD 0200 A that does not start?
If your BUSCH Water Pump doesn't start, it could be due to several reasons. First, check the power supply to ensure the motor is receiving the correct voltage. If the power supply is adequate, the motor itself may be defective and need replacement. Another potential issue is a defective coupling (CPL), which would also require replacement.
Why is my BUSCH R 5 RD 0200 A fuming or expelling oil droplets?
If your BUSCH Water Pump is fuming or expelling oil droplets, it could be due to a few reasons. The exhaust filters (EF) might be partially clogged and need replacing. Also, check that the exhaust filter (EF) with o-ring is correctly fitted. If these aren't the cause, the float valve (FV) may not be working properly. In this case, check the float valve.
What to do if my BUSCH R 5 RD 0200 A Water Pump runs very noisily?
If your BUSCH Water Pump is running very noisily, it could be due to worn coupling (CPL), which requires replacement. Alternatively, the vanes could be stuck, or the bearings could be defective.
Why is the oil in my BUSCH Water Pump black?
If the oil in your BUSCH Water Pump is black, it might be because the oil change intervals are too long. Another cause could be a defective inlet filter (optional), which should be replaced. Also, the machine may be running too hot.
What causes emulsified oil in my BUSCH R 5 RD 0200 A Water Pump?
If the oil in your BUSCH Water Pump is emulsified, it's possible that the machine sucked in liquids or significant amounts of vapour. Also, clean the filter of the gas ballast valve (GB).
General| Type | Rotary vane pump |
|---|---|
| Ultimate Vacuum | 0.1 mbar |
| Ultimate pressure | 0.1 mbar (0.075 Torr) |
| Gas type | Air, non-corrosive gases |
| Frequency | 50 Hz |
To Next Page