Busch+Müller IQ-X - Suspended Assembly

24
6.3 Suspended assembly
ATTENTION: If the headlight
1
is to be mounted in a suspended position, please ensure to not simply
turn it or place it upside down. Other road users would be dazzled!
!
In order to align the headlight correctly in a suspended position, loosen the plastic ring around the
headlight
1
and turn it by 180°. For this purpose, detach the headlight
1
rom the Busch + Müller
bracket
2
first and then slightly spread the circumferential plastic ring and move the ring around the
headlight
1
by 180°.
IMPORTANT: Make sure that the cable outlets on the headlight
1
always point straight down. This is
the only way to ensure that the light pattern of the headight
1
is ideally aligned and protected from
water penetration in the best possible way.
NOTICE
The headlight
2
must be mounted either upright (Busch + Müller bracket
2
and the cable
outlet pointing in exactly the same direction) or suspended and rotated by 180° (Busch + Müller bracket
2
and the cable outlet pointing in exactly the opposite direction). Otherwise, there is a risk that the
headlight
1
might adjust all by itself.
For suspended assembly, the reflector
3
must not be mounted „overhead“. Please mount the the reflec-
tor
3
elsewhere parallel to the road at a height between 400 and 1,200 mm.