22 Using your Outdoor DAB Radio
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Using your Outdoor DAB Radio
Let’s get started
Radio antenna
Before you use the radio, you must first screw the separate radio antenna into the top of
the radio, just above the volume control.
DAB Radio mode
Check that your Radio is in DAB mode. If you are not already in DAB mode, press and
release the Mode button until you are in DAB mode (check the display).
The first time you use the Radio or if the station list is empty, your radio will automatically
begin to scan for DAB radio stations. A progress bar will show the progress of the scan
and the number of stations found during the scan will also be displayed.
If you were listening to a DAB station when you switched the radio off, then this station
will automatically be selected when you switch the radio back on.
Changing DAB stations
1. Turn and release the Tune control to scroll through the available stations.
2. When the station that you would like to listen to is displayed, press the Enter button to
select it. There will be a short delay whilst your radio tunes to your selected station.
Scanning for DAB stations
With DAB radio, additional stations and services regularly become available so it’s a good
idea to carry out a manual scan every now and then to make sure that you have the most
up to date station listing stored within the memory of your Radio. If you have moved your
Radio to another location, e.g.: if you go on holiday, then it’s also a good idea to carry out
a manual scan.
In DAB mode:
1. Press and release the Scan button to begin a search for stations. The display will
change to ‘Scanning...’. A progress bar will show the progress of the scan and the
number of stations found during the scan will also be displayed.
To Next Page
Loading...
