32 Using your Outdoor DAB Radio
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Using your Outdoor DAB Radio
Let’s get started
11. Use the Tune control to set the volume for your alarm. Press and release the Enter
button.
Note: Remember to set the alarm radio volume to one that will wake you. The alarm
volume will increase progressively until it reaches the alarm volume you have set.
12. Alarm 1 Wizard is displayed again, together with Alarm Off (or On). Use the Tune
control to choose Alarm On or Off and press and release the Enter button to confirm.
Alarm Saved is displayed.
13. A bell symbol in the top right of the radio display, together with the digit ‘1’ or ‘2’ as
appropriate, will confirm that an alarm has been set.
Note: If the time is not set or has failed to update from the radio signal, Time is not set
will be displayed when you try to set the alarm. The radio will then prompt you to set
the time. An alarm can only be set after the time has been set.
Stop the Alarm
When the alarm sounds, press and release the Standby button, Alarm off is displayed.
Alternatively, you can press and release the Snooze button (see Snooze function below).
Note: If you press the Standby button to stop the alarm, the alarm symbol will remain in
the display and the alarm will sound again at the same time the next day, unless it was
set for ‘Once’ only.
Snooze
When the alarm sounds you can press and release the Snooze button. Snooze 5 minutes
will be displayed, followed by the snooze time countdown, until the alarm sounds again.
Turn o the Alarm
Follow the steps for ‘Setting an Alarm’ and select ‘Off’ in step 12.
To Next Page
Loading...
