18
Customer Helpline 0845 600 4632
Trouble Shooting
If your refrigerator is not working properly there may
be a minor problem, therefore check the following.
If the appliance does not operate, check if;
• There is a power failure,
• The mains plug is not properly plugged in,
or is loose
• The thermostat setting is on position “0”
• The socket is defective. To check this, plug in a
fully operable appliance into the same socket
If the appliance performs poorly, check if;
• You have overloaded the appliance
• The doors are not closed perfectly
• There are not enough ventilation ducts on
the kitchen unit as mentioned in the safety
instructions section of this instruction manual
(Page. 4)
If there is noise;
The cooling gas which circulates in the refrigerator
circuit may make a slight noise (bubbling sound)
even when the compressor is not running. Do not
worry, this is quite normal. If these sounds are
different check if;
• The appliance is installed fi rmly as described in
the Installation section of this manual (Page. 6)
• Objects on the appliance are vibrating
If there is water in the lower part of the refrigerator,
check if;
The drain hole for the defrost water is clogged up
(use the defrost drain plug to clean the drain hole).
IMPORTANT NOTES
• In case of a sudden power loss or disconnecting
reconnecting of the plug to the electrical socket,
the compressor’s protective thermal element
will be opened as the pressure of the gas in
the cooling system of your refrigerator has not
yet been balanced. 4 or 5 minutes later, your
refrigerator will start to operate; this is normal.
• If you will not be using your refrigerator for a
long period (holiday etc.), disconnect the plug
from the socket. Clean your refrigerator as per
page 13 of this document and leave the door
open to prevent any humidifi cation or odour
forming. If there is still a problem with your
refrigerator despite following the instructions
in this manual, please consult your nearest
authorised service centre, or contact the
Customer Helpline on 0845 600 4632
The life-cycle of this product, as determined and
proclaimed by the Ministry of Industry (the period
for making spare parts available for the product
to be able to fulfi l its function), is 10 years.
Conformity Information
• Normal Class is defi ned as environment
temperatures between 16°C and 32°C in
accordance with TS EN ISO 15502 standards.
• The appliance is designed in compliance
with EN15502, IEC60335-1/IEC60335-2-24,
2004/108/EC standards.
To Next Page
Loading...
