Installing your Built-in Hob
Bringing it all together
• Cut out the work surface according to the sizes shown in the
drawing.
• For the purpose of installation and use, a minimum of 50mm
space shall be preserved around the hole
• Be sure the thickness of the work surface is at least 30mm. Please
select heat-resistant work surface material to avoid larger deformation
caused by the heat radiation from the hotplate. As shown below:
Warning: The work surface material must use the impregnated wood
or other insulation material.
Getting to know your Built-in Hob
15
or online at www.bush-support.com If you still require further assistance, call one
of our experts
on 01759 487838
L(mm) W(mm) H(mm) D(mm) A(mm) B(mm) X(mm)
BLSINDH60
590 520 58 54 560 490 50 mini
NOTE: Make sure the hob is well ventilated and the air inlet and outlet are not blocked.
Ensure the hob is in good work state. As shown below Note: The safety distance between the
hotplate and the cupboard above the hotplate should be at least 760mm.
To Next Page
Loading...
