Using your
Built-in Hob
Getting the most from your
appliance
Using your Built-in Hob
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Using your Hob
To start cooking
• After power on, the buzzer beeps once, all the indicators light up for 1 second then go out, indicating
that the hob has entered the state of standby mode.
1. Touch the ON/OFF switch. all the indicators show “– “
2. Place a suitable pan on the cooking zone that you
wish to use.Make sure the bottom of the pan and the
surface of the cooking zone is clean and dry.
3. Touching the heating zone selection
control, and an
indicator next to the key will flash
4. Select a heat setting by touching the “-” “+”control.
• If you don’t choose a heat setting within 1 minute, the
Induction hob will automatically switch off. You will
need to start again at step 1.
• You can modify the heat setting at any time during
cooking.
When you have finished cooking
1. Touching the heating zone selection that you wish to
switch off
2. Turn the cooking zone off by scrolling down to“0”.
Make sure the display shows“0”.
3. Turn the whole cooktop off by touching the ON/OFF
control.
22
To Next Page
Loading...
