Installing your Built-in Hob
Bringing it all together
Installing your Built-in Hob
18
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Cautions
The hob must be installed by qualified personnel or technician. We have
professionals at your service. Please never conduct the operation by yourself.
The hob shall not be mounted to cooling equipment, dishwashers and rotary dryers.
The hob shall be installed such that better heat radiation can be ensured to enhance
its reliability.
The wall and induced heating zone above the work surface shall withstand heat.
To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
A steam cleaner is not to be used.
Connecting the hob to the mains power supply
The power supply should be connected in compliance with the relevant standard, or a
single-pole circuit breaker.
Warning: Connect the power cord to main power supply in accordance with the instruction
listed in the table below:
Wire cross-sectional area(mm
2
)
L N E
Min 2.5 Min
2.5
Min
2.5
Before the appliance is connected with the mains, please do assemble one full polar
breaker with over 2.5mm opened on the mains, and the rated current of the breaker is
strongly recommend over 27A.
If the cable is damaged or needs replacing, this should be done by an service
technician using the proper tools, so as to avoid any accidents.
If the appliance is being connected directly to the mains supply, an omnipolar circuit
breaker must be installed with a minimum gap of 3mm between the contacts.
The installer must ensure that the correct electrical connection has been made and
that it complies with safety regulations.
The cable must not be bent or compressed.
The cable must be checked regularly and only replaced by a proper qualified person
Power cord is not accessible after installation.
To Next Page
Loading...
