Software version
You can check the software version of your radio.
With your radio switched on (not in Standby mode):
1. Press and release the Menu button to enter the menu options
2. Use the Tune/Select control to scroll to <System>. Press to Select.
3. Use the Tune/Select control to scroll to <SW Version>. Press to Select.
The software version will be displayed and you may wish to make a note of it here:
...................................................................................
Factory reset
You can reset your radio and restore all of the original factory settings.
Note: If you reset your radio all of your stored station presets will be deleted.
With your radio switched on (not in Standby mode):
1. Press and release the Menu button to enter the menu options
2. Use the Tune/Select control to scroll to <System>. Press to Select.
3. Use the Tune/Select control to scroll to <Factory reset>. Press to Select. Factory
Reset? <No> Yes will be displayed.
4. Use the Tune/Select control to scroll to <Yes>. Press to Select.
5. Restarting... will be displayed. After a few seconds the display will change to Welcome
to Digital Radio and will then go to Standby mode. When you next power on your
radio from Standby mode, it will begin an automatic scan for DAB stations. A progress
bar will show the progress of the scan and the number of stations found during
the scan will also be displayed. When the scan is complete your radio will select
the first available station and begin to play. Stations are listed in numerical and then
alphabetical order by default.
Technical specification
Power adaptor. Output DC 6V 1.5A
Input AC 100-240V, 50/60Hz
Audio output: 2 x 1.5W RMS
Frequency range:
DAB: Band III, 174 MHz to 240 MHz
FM: 87.5 MHz to 108 MHz
To Next Page
Loading...
