Bush DAB30 - Software version and reset

This page is left intentionally blank
37
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Using your DAB/FM Radio with Bluetooth
Let’s get started
Using your DAB/FM Radio with Bluetooth
36
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Software version
You can check the software version of your radio.
In DAB or FM mode:
1. Press and hold the Menu/Info button to enter the menu options
2. Use the Tune/Select rotary control to scroll to ‘<System>’. Press the Tune/Select rotary
control to select.
3. Use the Tune/Select rotary control to scroll to ‘<SW Version>’. Press the rotary control
to select.
The software version will be displayed and you may wish to make a note of it here:
...................................................................................
4. Press and release the Menu/Info button to return to the station display.
Factory reset
You can reset your radio and restore all of the original factory settings.
Note: If you reset your radio all of your stored station presets will be deleted.
In DAB or FM mode:
1. Press and hold the Menu/Info button to enter the menu options
2. Use the Tune/Select rotary control to scroll to ‘<System>’. Press the Tune/Select rotary
control to select.
3. Use the Tune/Select rotary control to scroll to ‘<Factory reset>’. Press the Tune/Select
rotary control to select.
4. ‘Factory Reset? <No> Yes’ will be displayed. Use the Tune/Select rotary control to scroll
to ‘<Yes>’. Press the Tune/Select rotary control to select.
5. ‘Restarting...’ is displayed. After a few seconds ‘Welcome to Digital Radio’ will be
displayed.