Bush Q5S - Standby Mode; Switching Inputs; Adjusting the Volume; LED Status Table

Using your Soundbar
Let’s get started
Using your Soundbar
14
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Standby mode
This unit is designed to enter STANDBY mode
automatically after 20 MINUTES (approximately) of
inactivity. Press the STANDBY button to wake the
unit.
1. Press the STANDBY button on the unit (1) or press
the STANDBY button on the remote to put the
system into standby mode.
2. To resume normal operation press either button
again.
Switching inputs
Follow the below steps to switch inputs between :
Auxiliary, Coaxial, Bluetooth or Optical.
1. Ensure the Sound bar is powered ON. If not press
the STANDBY button on the unit (1) or remote.
2. Press the SOURCE button on the unit (3) or remote
repeatedly until you reach the required input
mode.
• Auxiliary input GREEN LED
• Coaxial input WHITE LED
• Optical input PURPLE LED
• Bluetooth input BLUE LED
When switching inputs there will be a 2 second
pause after selecting BT while the unit scans for
paired devices.
Adjusting the volume
1. To increase the volume level press the VOLUME+
button on the main unit (2) or remote repeatedly
or press and hold for fast adjustment. The status
LED will blink accordingly.
2. To decrease the volume level press the VOLUME-
button on the main unit (2) or remote repeatedly
or press and hold for fast adjustment. The status
LED will blink accordingly.
LED status table
The below table explains the LED indications.
Operation Description Action
Standby Standby RED (Solid)
Source Aux GREEN (Solid)
Coaxial WHITE (Solid)
Optical PURPLE (Solid)
Bluetooth paired BLUE (Solid)
Bluetooth ready
for pairing
BLUE (Flash)
Vol +/- Adjust volume Current input
colour (blink once)
Bass +/- Adjust bass level Current input
colour (blink once)
Sound EQ Assign EQ mode Current input
colour (blink once)
Mute Mute sound RED (Flash)
EQ presets
1. Press the SOUND EQ button on the remote
control repeatedly to cycle through the EQ sound
modes. The status LED will blink accordingly.
Choose between :- STANDARD (STD) or MOVIE.
Bass enhancement
1. To increase the bass press the BASS + button on
the remote. The status LED will blink accordingly.
2. To decrease the bass press the BASS - button on
the remote. The status LED will blink accordingly.
The BASS levels range from -3 to +3.
Mute function
1. Pressing the MUTE button on the remote will
temporarily silence the audio output. The status
LED will blink accordingly.
2. Press the MUTE button again to resume the audio
output. The status LED will blink accordingly.