Voice message feedback
Follow the below steps to enable the voice message
when performing tasks.
1. Enter STANDBY mode if not already.
2. Press and hold the
PLAY/PAUSE button on the
remote for 5 seconds.
3. Repeat the same process to disable the voice
message when enabled.
Pairing a bluetooth device
Before you can use the sound bar with your phone or
other bluetooth capable device you will need to pair
the device to the sound bar.
1. Press the SOURCE button on the main unit (3) or
remote repeatedly until you see the blue LED.
2. When selected the status LED will flash while the
unit tries to connect to previously paired devices.
If no devices are found the status LED will remain
flashing to indicate it is ready for pairing a new
device.
3. Enable the Bluetooth function on your audio
device and search for a device labelled ‘BUSH Q5S’
in the available list.
4. Select and enable pairing for the ‘BUSH Q5S’
device. If prompted for a password enter ‘0000’.
5. If pairing is successful the sound bar will beep and
the STATUS LED will stop flashing.
6. If the connected device goes out of range, the
sound bar will attempt to connect for 2 minutes.
When the device comes into range the sound bar
will reconnect again automatically.
7. To remove a paired device using only the sound
bar, press and hold the PLAY/PAUSE button on the
remote control for 5 seconds. The STATUS LED
will begin flashing once more.
Bluetooth LED status table
Status LED Reason
Solid blue (No flash) Connected
Blue flashing Auto reconnecting with the
last paired device.
Pairing mode.
Controlling a paired device
Once connected you can either use the controls on
the audio device to begin playback, skip tracks etc.
Or you can use the control buttons on the sound bar &
remote.
1. The
PLAY/PAUSE button on the remote when
pressed will begin playback of the selected
track on the audio device. Press again to pause
playback.
2. To skip to the next track press the SKIP
button
on the remote.
3. To skip to the previous track press the SKIP
button on the remote.
4. Any further operations must be done from the
audio device.
The volume output is effected by the volume level
on the audio source EG: Phone or laptop, so make
sure that is set to about 70-80% ( not too loud to
avoid distortion).
Bluetooth notes
• The operation range of bluetooth is approximately
10 meters (30 Feet). Any obstacles in the path
between devices may reduce this range.
• Only one Bluetooth device can be paired at a time.
• Not all Bluetooth devices are compatible.
To Next Page
