BUTURE JR400 - Starting and Adjusting Suction; Adjusting Tube Length

188
188
188
• There is a suction slider on the host control panel, which can be slid to any position of
the slider to adjust the suction. Stepless suction adjustment, easy sliding, convenient
for your operation.
• The remaining power value will be displayed on the control panel, and there are also
3 power indicator lights on the battery. When the battery is turned on, when the battery
power is less than 10%, the light on the battery will turn on red as a charging reminder.
(Note: The battery indicator will not light up when shutting down)
1.Clean the dust cup.
To maintain good suction power, please empty the dust cup and clean the filter after
each use.
• Press the release button on the dust cup to open the dust cup lid, dump out the trash.
CLEANEING
100
SLIP TO MAX
MIN
100
SLIP TO MAX
MIN
100
SLIP TO MAX
MIN
sales@ibuture.com
EN
01 02 03 04 05 06 07 08 09 10 11 12
13 14 15 16 17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32 33 34 35 36
37 38 39 40 41 42 43 44 45 46 47 48
49 50 51 52 53 54 55 56 57 58 59 60
61 62 63 64 65 66 67 68 69 70 71 72
5. According to different needs, the length of the tube can be adjusted.
When you need to extend the tube, press the button behind the tube and extend the
tube at the same time. When you need to shorten it, press the button and pull the tube
back.
4. Adjust suction power.
3. Press the ON/OFF button to start work.