WARNING
This transmitter should never be operated without a suitable antenna or test dum-
my load! Failure to observe this requirement may result in damage to the transmit-
ter that is not covered by the warranty.
IMPORTANT
This transmitter has been shipped with the internal stereo generator enabled. The
internal jumper J1 (MPX loop-through) is set to ON.
If you intend to connect a MPX signal to the MPX input BNC connector you will
need to move J1 (MPX loop-through) to the OFF position.
Examples of congurations requiring setting J1 to OFF include:
Routing the internal MPX signal through an external RDS encoder.
Connecting an external audio processor or stereo generator to the
transmitter.
Connecting a re-broadcast or STL receiver to the transmitter.
Consult the manual for further information on the transmitter’s jumpers and con-
nections.
●
●
●
To Next Page
Loading...
