What to do if my BWT Water Filtration System is leaking?
If water leaks from the device, immediately disconnect the unit from both the power supply and the water network. Then, call the SERVICE team for assistance.
Why is there no raw water in my BWT Water Filtration System?
There could be several reasons for this issue. First, check if the shut-off valves are closed or if there are any other blockages at the inlet; if so, open the main stop valves and ensure the water supply is properly connected. Next, verify that the water supply pressure is within the range of 2.0 to 6.0 bar. Finally, inspect the prefilter for any blockages and replace it if necessary, following the operating instructions for the external prefilter.
General| Brand | BWT |
|---|---|
| Model | bestaqua 6 |
| Category | Water Filtration Systems |
| Language | English |
Defines the suitable applications and conditions for the RO unit's operation.
Guidelines for safe and permitted operational modes, including water quality advice.
Further details on safe operation, user roles, and handling shutdown periods.
Guidelines for positioning, connections, and environmental conditions for installation.
Requirements for feed water quality, temperature, and operating pressure.
Rules for water pipe connections, hose assembly, and concentrate flow.
A concise guide to controlling the device and understanding its basic operation.
Identification and function of all control keys and display components.
Detailed instructions for turning the device ON, pausing, and completely switching it OFF.
Introduction to the four main menu items: AUTO RINSE, SERVICE, SETUP, STOP DELAY.
Overview of the SETUP menu for general device settings.
Procedure for configuring the device's current date and time.
Steps to set the device's operating mode to ONLINE or OFFLINE.
Troubleshooting for alarms like SERVICE, No raw water, and leakage.
Troubleshooting specific fault codes related to pump and sensor issues.
To Next Page