BYD Battery-Box HV series Quick Installation Guide

BCU
B-Plus H 2.5
Base
Overall structure
BYD Battery-Box HV
QUICK INSTALLATION GUIDE
Valid for Battery-Box H 5.0/7.5/10.0
Tools
USA V 1
Skilled personnel recognized
This manual and the tasks and procedures described herein are intended for use by skilled workers only.
A skilled worker is defined as a trained and qualified electrician or installer who has all of the following skills and experience:
• Knowledge of the functional principles and operation of on-grid systems.
• Knowledge of the dangers and risks associated with installing and using electrical devices and acceptable mitigation methods.
• Knowledge of the installation of electrical devices.
• Knowledge of and adherence to this manual and all safety precautions and best practices.
Important
Installation environment requirements
Max.
+50℃
Min.
-10℃
Flammable material or
gas near the installation
Flammable wall
RH.
+5%~+95%
Packing list
Packing of BCU+BASE
Packing of B-Plus H 2.5
① M6 ×6PCS
④ M6 ×4PCS
② M6 Expansion bolt ×3PCS
③ OT terminal for P+/P-/Ground×4PCS
Wire Crimp
Power drill
Direct sunlight
Direct rain fall
Snow
accumulation
YES
NO NO
YES
NO
NO
NO
Wrench
• You must update the lastest firmware of BCU after completing the Battery-Box H 5.0-10.0,the installer is responsible for system
damage caused by not updating the software in time. Before installing BCU, make sure the system switch is switch off.
•
If the system does not work, please switch off the system switch before you leave to avoid damage caused by the event.
YES
Battery-Box H 5.0
Battery-Box H 7.5
Battery-Box H 10.0
Levelling instrument
Phillips screwdriver
M6/M4 Precision screwdriver

BYD Battery-Box HV series Specifications

General

Battery Type	Lithium Iron Phosphate (LFP)
Protection Class	IP55
Operating Temperature Range	-10°C to +50°C
Communication Interface	CAN
Certifications	UN38.3, CE, IEC 62619
Cycle Life	6000 cycles
Efficiency	>95%