F6 OWNER’S MANUAL
131
The capability of cooling system as
following:
BYD483QB engine
MT：
6.3 L
Mitsubishi 4G69S4M engine
AT:
7.2 L
10．Run the engine about 30 seconds, then
turn it off.
11．Pour the coolant into radiator, till the
level is up to the bottom of the filler neck.。
12．Pour the coolant into coolant reserve
tank to the MAX mark, cover the cap.
13．Put the radiator cap back, and tighten to
first stop position.
14．Run the engine itself, till the cooling fan
at least starts two times, then turn off the
engine.
15．Get down the radiator cap, then pour the
coolant and make the level up to the bottom
of the filler neck and MAX mark of reserve
tank.
16．Start the engine and keep the speed at
1500 r/m, till the cooling fan starts, then
turn off the engine. Check the coolant level
in the radiator, pour the coolant if necessary.
17．Put the radiator cap back and tighten it.
18．If necessary, pour the coolant into
reserve tank up to MAX mark, then cover
the cap.
To Next Page
Loading...
