F6 OWNER’S MANUAL
161
4．Pull out the ground cable and power
cable, then press the clip reed and pull out it,
and take out the bulb.
5．Replace the bulb, press the clip reed and
push it into the fixed frame, make sure the
bulb is locked
6．Plug the power cable and ground cable,
make sure it is fully connected, and don’t
loose.
7．Rotate in the sealing cover.
8．Connect the connecter of electric device,
make sure it is well connected.
9．(Driver side)
Install the battery.
10．Open the headlight to test the new bulb
Front position light
1．Pull out the key from ignition switch,
open the engine hood. To replace the bulb of
driver side, disassemble the battery. To
replace the bulb of driver side, make the
next step.
To Next Page
Loading...
