F6 OWNER’S MANUAL
160
7．Close the sealing cover.
8．Connect the connecter of electric device,
make sure it is well connected.
9．(Driver side)
Install the battery.
10．Open the headlight to test the new bulb.
Low beam
1．Pull out the key from the ignition switch,
open the engine hood. If need replace the
bulb of driver side, should disassemble the
battery. To replace the bulb of driver side,
make the next step.
2．Press the reed, pull out the connecter of
electric device.
3．Rotate out the sealing cover.
To Next Page
Loading...
