F6 OWNER’S MANUAL
81
Before don’t set the time or battery is
disconnected、 or anew charge after power
exhausted, the display of time will always
twinkle to remind to set the time.
USB/AUX input operation
The system can play music of MP3 format
in U disk through USB interface and play
music through speaker-on board, and the
music is from the input audio signal through
AUX interface.
When inserting the connective device of
USB, the system will automatic shift into
USB mode, meanwhile play the music of
MP3 format in the storage device. Like the
CD music, you can make the operation
PLAY/PAUSE、 & and so on.
When the earphone jack and AUX faucet
which can connect the MP3 by data wire on
board is shifted to
AUX mode, the MP3 player will play music
which can be heard.
Notice：
1、Suggest using the data wire on board to
connect the U disk to avoid causing possible
damage；
2、USB interface don’t support a part of
mobile hart disk whose compatibility is bad
and the capacity of U disk exceed 1GB;
3、USB interface only supports music file of
the FAT file system MP3 format;
4、USB interface mayn’t support the USM
store device whose compatibility is bad.
CD disc play
To play the laser disc, must turn the laser
disc to ACCESSORY( ) or ON( ).ⅠⅡ
The operation of laser phonograph is same
with the radio. To choose the laser
phonograph, press the CD button. The
screen will display the “ CD” & program
number which is being played. The system
will play the disc until you change the mode.
Insert the laser disc into player. The driver
will play the music. When finish the music,
the system will anew play it.
Notice：
The CD player only can play the normal CD
format, can’t play record disc compressed
such as MP3 and WMA.
Don’t use the disc which has the sticky
label.
The label possibly makes the disc locked in
the device
.
Don’t play the 8 cm ( 3 inch) disc. Only
allow to play the round standard disc. The
abnormal disc may be locked in the driver
or cause the malfunction.
To get the best effect of CD-R, only use the
advanced disc which has the label “be used
in sound system”, when transcribing the
CD-R disc, the transcribe should be totally
close, only this, the disc can be played in
the laser phonograph. The device can’t play
the CD-RW disc.
When playing the disc, press AM／FM
button, and can shift to radio mode. Press
the CD button again, and can return to CD
play mode, and the disc will begin to play
from the last position.
When playing, using the (PWR ／ VOL)
knob or closing the system by closing
ignition switch, the disc will stay in driver.
Open the system once more, the
phonograph will play from the last position.
To Next Page
Loading...
