18
II.8 RUN AND STOP KEYS
The RUN key has three functions:
1. Press RUN to execute a timed measurement.
2. Press and hold the RUN key for continuous rotation when 00 is the timer
setting.
3. Used in executing a cone calibration.
The STOP key has three functions:
1. Stops the cone rotation at any time.
2. Pressing and holding the STOP/ESCAPE key during power up selects the
viscosity display units and speed of rotation.
3. Pressing and holding the STOP and PRINT keys simultaneously executes the
printingof a new heading (Section II.7).
Run and Stop Keys
To Next Page
Loading...
